10 Cubic Yards of Sand in Tons
10 cubic yards of sand in tons works out to about 13.5 tons using a planning weight of 1.35 tons per yard. Real loads land between roughly 13.0 and 15.0 tons depending on stone size, fines and moisture. That is about 27,000 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 10 × 1.35 = 13.5 tons.
- Low end: 10 × 1.3 = 13.0 tons.
- High end: 10 × 1.5 = 15.0 tons.
Quarries can tell you the weight per yard for their own product; use it if you have it.
What 10 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 3,240 |
| 2 in | 1,620 |
| 3 in | 1,080 |
| 4 in | 810 |
About sand
Sand weight changes a lot with moisture. Damp sand can weigh noticeably more per yard than dry sand, so a ton of wet sand covers less area than the same ton dry.
Hauling 10 yards
At about 13.5 tons, this is roughly a tandem-axle truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices sand by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
When to choose sand
Works well for:
- Paver and flagstone bedding
- Leveling under above-ground pools (with the right product)
- Filling joints and backfilling pipe
Less suited to:
- Driveway bases, since sand shifts under load
- Steep areas exposed to runoff
- Thick layers under pavers, which settle unevenly
Quick reference numbers
- Per inch over 100 sq ft: about 0.42 tons of sand (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.2 tons.
- Another size for comparison: a 12x24 area at 4 inches takes about 4.8 tons.
- Weight used here: about 1.35 tons per cubic yard.
Where estimates go wrong
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Questions people ask
How many tons is 10 yards of sand?
About 13.5 tons, with a typical range of 13.0 to 15.0.
How many pounds is 10 cubic yards of sand?
About 27,000 pounds.
How much area does 10 yards of sand cover at 3 inches?
About 1,080 square feet.
Why does sand weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- How Much Does a Ton of Sand Cover?
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 8 Cubic Yards of Sand in Tons
- 9 Cubic Yards of Sand in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.