17 Cubic Yards of Asphalt Millings in Tons
17 cubic yards of asphalt millings in tons works out to about 22.1 tons using a planning weight of 1.3 tons per yard. Real loads land between roughly 20.4 and 23.8 tons depending on stone size, fines and moisture. That is about 44,200 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 17 × 1.3 = 22.1 tons.
- Low end: 17 × 1.2 = 20.4 tons.
- High end: 17 × 1.4 = 23.8 tons.
If your supplier quotes a different weight per yard, multiply by theirs.
What 17 yards covers
| Depth | Square feet |
|---|---|
| 3 in | 1,836 |
| 4 in | 1,377 |
| 6 in | 918 |
About asphalt millings
Asphalt millings are ground-up old pavement. When compacted and warmed by sun they bind into a fairly firm surface, which is why they are popular for rural drives and lots.
Hauling 17 yards
At about 22.1 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices asphalt millings by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Good and poor uses for asphalt millings
Best suited to:
- Rural driveways and farm lanes
- Parking areas where a dust-free surface is wanted
- Low-cost base under a future paved surface
Poor fit for:
- Areas near wells or streams where local rules limit them
- Decorative or barefoot areas
- Jobs needing a uniform, clean look
Quick reference numbers
- Per inch over 100 sq ft: about 0.40 tons of asphalt millings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.0 tons.
- Another size for comparison: a 14x28 area at 3 inches takes about 4.7 tons.
- Weight used here: about 1.3 tons per cubic yard.
Common estimating mistakes
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Questions people ask
How many tons is 17 yards of asphalt millings?
About 22.1 tons, with a typical range of 20.4 to 23.8.
How many pounds is 17 cubic yards of asphalt millings?
About 44,200 pounds.
How much area does 17 yards of asphalt millings cover at 4 inches?
About 1,377 square feet.
Why does asphalt millings weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- How Many Tons of Asphalt Millings for a 40x25 Area?
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.