19 Cubic Yards of Sand in Tons
19 cubic yards of sand in tons works out to about 25.7 tons using a planning weight of 1.35 tons per yard. Real loads land between roughly 24.7 and 28.5 tons depending on stone size, fines and moisture. That is about 51,300 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 19 × 1.35 = 25.7 tons.
- Low end: 19 × 1.3 = 24.7 tons.
- High end: 19 × 1.5 = 28.5 tons.
If your supplier quotes a different weight per yard, multiply by theirs.
What 19 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 6,156 |
| 2 in | 3,078 |
| 3 in | 2,052 |
| 4 in | 1,539 |
About sand
For paver bedding, concrete sand (coarse, washed) is the usual pick. Mason sand is finer and used in mortar and play areas.
Hauling 19 yards
At about 25.7 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices sand by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Where sand fits
Best suited to:
- Paver and flagstone bedding
- Leveling under above-ground pools (with the right product)
- Filling joints and backfilling pipe
Think twice for:
- Driveway bases, since sand shifts under load
- Steep areas exposed to runoff
- Thick layers under pavers, which settle unevenly
Quick reference numbers
- Per inch over 100 sq ft: about 0.42 tons of sand (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.2 tons.
- Another size for comparison: a 8x16 area at 4 inches takes about 2.1 tons.
- Weight used here: about 1.35 tons per cubic yard.
Mistakes that throw off the order
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
Questions people ask
How many tons is 19 yards of sand?
About 25.7 tons, with a typical range of 24.7 to 28.5.
How many pounds is 19 cubic yards of sand?
About 51,300 pounds.
How much area does 19 yards of sand cover at 3 inches?
About 2,052 square feet.
Why does sand weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- How Much Does a Ton of Sand Cover?
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 17 Cubic Yards of Sand in Tons
- 18 Cubic Yards of Sand in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.