20 Cubic Yards of Limestone Screenings in Tons
20 cubic yards of limestone screenings in tons works out to about 28.0 tons using a planning weight of 1.4 tons per yard. Real loads land between roughly 26.0 and 30.0 tons depending on stone size, fines and moisture. That is about 56,000 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 20 × 1.4 = 28.0 tons.
- Low end: 20 × 1.3 = 26.0 tons.
- High end: 20 × 1.5 = 30.0 tons.
Quarries can tell you the weight per yard for their own product; use it if you have it.
What 20 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 6,480 |
| 2 in | 3,240 |
| 3 in | 2,160 |
About limestone screenings
Limestone screenings are the fine dust and chips left after crushing limestone. They pack very tight, which makes them a common setting bed for pavers and flagstone and a surface for paths.
Hauling 20 yards
At about 28.0 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices limestone screenings by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
When to choose limestone screenings
Good uses:
- Paver and flagstone setting beds
- Firm walking paths
- Top-dressing a compacted stone base
Poor fit for:
- Deep layers on their own
- Low spots that collect water
- Under heavy vehicle traffic without a base
Quick reference numbers
- Per inch over 100 sq ft: about 0.43 tons of limestone screenings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.3 tons.
- Another size for comparison: a 15x30 area at 2 inches takes about 3.9 tons.
- Weight used here: about 1.4 tons per cubic yard.
Mistakes that throw off the order
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
Questions people ask
How many tons is 20 yards of limestone screenings?
About 28.0 tons, with a typical range of 26.0 to 30.0.
How many pounds is 20 cubic yards of limestone screenings?
About 56,000 pounds.
How much area does 20 yards of limestone screenings cover at 2 inches?
About 3,240 square feet.
Why does limestone screenings weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- #10 Stone (Stone Dust): Size, Uses and How Many Tons
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 18 Cubic Yards of Limestone Screenings in Tons
- 19 Cubic Yards of Limestone Screenings in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.