40 Cubic Yards of Limestone Screenings in Tons
40 cubic yards of limestone screenings in tons works out to about 56.0 tons using a planning weight of 1.4 tons per yard. Real loads land between roughly 52.0 and 60.0 tons depending on stone size, fines and moisture. That is about 112,000 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 40 × 1.4 = 56.0 tons.
- Low end: 40 × 1.3 = 52.0 tons.
- High end: 40 × 1.5 = 60.0 tons.
Quarries can tell you the weight per yard for their own product; use it if you have it.
What 40 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 12,960 |
| 2 in | 6,480 |
| 3 in | 4,320 |
About limestone screenings
Screenings hold moisture and can crust over. Use them in thin layers over a compacted stone base instead of as a thick layer on their own.
Hauling 40 yards
At about 56.0 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices limestone screenings by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Where limestone screenings fits
Good uses:
- Paver and flagstone setting beds
- Firm walking paths
- Top-dressing a compacted stone base
Poor fit for:
- Deep layers on their own
- Low spots that collect water
- Under heavy vehicle traffic without a base
Quick reference numbers
- Per inch over 100 sq ft: about 0.43 tons of limestone screenings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.3 tons.
- Another size for comparison: a 14x28 area at 4 inches takes about 6.8 tons.
- Weight used here: about 1.4 tons per cubic yard.
Mistakes that throw off the order
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
Questions people ask
How many tons is 40 yards of limestone screenings?
About 56.0 tons, with a typical range of 52.0 to 60.0.
How many pounds is 40 cubic yards of limestone screenings?
About 112,000 pounds.
How much area does 40 yards of limestone screenings cover at 2 inches?
About 6,480 square feet.
Why does limestone screenings weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- #10 Stone (Stone Dust): Size, Uses and How Many Tons
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 25 Cubic Yards of Limestone Screenings in Tons
- 30 Cubic Yards of Limestone Screenings in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.