6 Cubic Yards of River Rock in Tons
6 cubic yards of river rock in tons works out to about 8.1 tons using a planning weight of 1.35 tons per yard. Real loads land between roughly 7.5 and 8.7 tons depending on stone size, fines and moisture. That is about 16,200 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 6 × 1.35 = 8.1 tons.
- Low end: 6 × 1.25 = 7.5 tons.
- High end: 6 × 1.45 = 8.7 tons.
The scale ticket on delivery day is the final word on weight.
What 6 yards covers
| Depth | Square feet |
|---|---|
| 2 in | 972 |
| 3 in | 648 |
| 4 in | 486 |
About river rock
River rock is smooth, water-worn stone sold in sizes from about 3/4 inch to several inches. Larger sizes cover fewer square feet per ton at the same depth because the voids between stones are bigger.
Hauling 6 yards
At about 8.1 tons, this is a load most single-axle dump trucks can take. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices river rock by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Where river rock fits
Best suited to:
- Dry creek beds and drainage swales
- Decorative borders and planting beds
- Around downspouts to stop splash erosion
Less suited to:
- Walking surfaces
- Driveways
- Bases under slabs or pavers
Quick reference numbers
- Per inch over 100 sq ft: about 0.42 tons of river rock (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.2 tons.
- Another size for comparison: a 8x16 area at 3 inches takes about 1.6 tons.
- Weight used here: about 1.35 tons per cubic yard.
Where estimates go wrong
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Questions people ask
How many tons is 6 yards of river rock?
About 8.1 tons, with a typical range of 7.5 to 8.7.
How many pounds is 6 cubic yards of river rock?
About 16,200 pounds.
How much area does 6 yards of river rock cover at 3 inches?
About 648 square feet.
Why does river rock weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- How Much Does a Ton of River Rock Cover?
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 4 Cubic Yards of River Rock in Tons
- 5 Cubic Yards of River Rock in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.