AsphaltTons.com — asphalt tonnage calculator

Asphalt Tarp for Dump Trucks: Heat Ratings, Sizing and Specs

An asphalt tarp is the cover that rolls over a dump body after it is loaded with hot mix. It looks like any other truck tarp, but it has a different job. It has to sit on mix fresh from the plant without melting, sticking or burning through, and it has to keep wind and rain off the load so the mix shows up hot enough to compact. A mesh tarp that is fine for gravel does neither.

This guide covers what separates an asphalt tarp from a regular dump truck tarp, the heat ratings and fabric weights makers actually publish, what a state DOT spec can require, and how to size one for your body. A worked sizing example is near the end.

How many tons of asphalt fit in a dump truck →

Why hot mix gets its own tarp

Hot mix starts cooling the moment it drops into the bed, and the surface of the pile loses heat fastest. The Asphalt Paving Handbook published by the National Asphalt Pavement Association (section 6.5.2) says keeping plant temperature during the haul is "imperative." It treats a temperature difference of 25°F or more within the mix as thermal segregation, and it notes that cool days and long hauls make that more likely. Its ideal setup is an insulated bed plus a waterproof, insulating cover that overlaps the sides and back of the bed by at least 1 ft, to keep moving air and rainwater off the mix.

Crusted, cold chunks from the top and corners of a load are what show up later as cold spots and rough patches in the mat. Our article on how haul time cools a load of hot mix explains where in the load the heat goes. The tarp is the cheapest part of the fix.

Asphalt tarp vs. mesh and standard vinyl

Truck tarp makers sell three broad kinds of fabric, and only one is meant for hot asphalt:

  • Mesh. Pulltarps describes its 11 oz and 18 oz mesh tarps as an open weave that lets air pass through to cut wind load, and says they suit rock, sand, debris and similar loads that don't need to be fully waterproof or windproof. That same airflow is exactly what strips heat off hot mix.
  • Waterproof vinyl. Solid, seamless vinyl keeps out rain and wind. Some listings sold for "asphalt, gravel, sand" don't publish any heat rating, so check before you assume it can sit on a hot load all day.
  • Asphalt (heat-rated) vinyl. Solid vinyl with a coating or construction the maker rates for hot loads. Pulltarps says its asphalt tarps have a heat-rated urethane coating that won't stick to the mix or let it burn through.

Published asphalt tarp specs

The figures below are copied from each maker's own product page. They are examples, not a ranking. Note how the heat ratings differ.

TarpFabricStated heat ratingOther details from the maker
Pulltarps asphalt tarp14 oz vinyl, urethane coatedUp to 400°FWaterproof; grommets every 3 ft; hem tubes on both ends; universal 14 ft × 84 in size listed
Roll-Rite heat resistant asphalt tarp (sold by American Tarping)15 oz vinyl, urethane coated on both sidesUp to 400°FCold-crack resistance down to -22°F; single-piece; lined, grommeted rear rod pocket
Harp's Tarps LSA and AS asphalt tarps18 oz seamless vinylUp to 300°F6 in pocket for the roller crossbar; AS style adds 18 in side flaps
Ramken LSA asphalt tarp18 oz vinyl, seamlessUp to 300°FPre-stocked and custom sizes for dump beds
Carolina Tarps Hot Top (RFL) with side flapsWoven heat-resistant fabric (not vinyl)Sold for hot asphalt; no degree figure on the category page12 in side flaps; seamed, so the maker says it is not 100% waterproof

Two takeaways. First, a heavier fabric is not automatically a higher heat rating: the 14 and 15 oz urethane-coated tarps above carry the 400°F rating, while the 18 oz plain vinyl tarps list 300°F. Second, if you work on public jobs, the spec may name a number. New Jersey's, covered below, calls for a tarp that can handle up to 400°F and, for the drape style, at least 18 oz per square yard.

Carolina Tarps is unusually candid about its Hot Top fabric: it is lighter and easier to handle than vinyl, but because the fabric only comes in narrow widths a seam is needed, and the company says some DOT officials have issues with it. Its advice is to check with your inspector before ordering.

What a DOT spec can require

Tarping rules for hot mix come from two places: state load-cover laws that apply to every truck, and the project specification, which is usually stricter. Two published examples show the range.

New Jersey: airfoil, 400°F and two allowed styles

NJDOT's Baseline Document Change BDC02S-17 (October 28, 2002) rewrote Subsection 404.06, "Vehicles for Transporting HMA Mixtures," to keep mix from crusting during transport. Under that text:

  • Every load is covered right after loading at the plant with a waterproof tarp big enough to protect the mix from weather.
  • The tarp must handle normal handling and placement temperatures up to 400°F without losing its structural integrity.
  • Trucks need a permanently mounted airfoil, no more than 2 ft in front of the tarp roll and at least as high as its top, so air goes over the tarp instead of under it.
  • The tarp must meet one of two options: a heavyweight drape of at least 18 oz/yd², at least 2 ft wider and 4 ft longer than the body, meeting or overlapping the top of the tailgate; or a tarp with side and back flaps that lap down outside the bed at least 12 in, held by tie-downs no more than 5 ft apart.
  • Bodies are insulated or heated as needed to deliver mix at the specified temperature, and a truck without an airfoil or an approved tarp is removed from the work until fixed.

That bulletin is from 2002, so check NJDOT's current standard specifications for the wording in force on your contract. It is still a clear picture of what a strict agency looks for.

Colorado Springs: covered, with a cold-weather trigger

The City of Colorado Springs' Section 400 asphalt spec is simpler. Section 404.01 says each load is covered with canvas or other suitable material large enough to protect it from bad weather. Section 404.07 adds that when the air is below 50°F, all loads are delivered continuously in covered vehicles, and that mix delivered to the job may not be below 225°F.

Rules like these vary by agency and by contract, so the only safe answer to "is my tarp legal for this job" is the project spec and the inspector. For private driveway and parking lot work there is usually no spec at all, which is why it is worth asking a contractor whether the trucks are tarped.

Flaps or no flaps

Most dump bodies use a roll tarp that runs front to back on a crossbar. A plain tarp covers the top of the load. A flap tarp adds strips along the sides that hang down over the outside of the bed walls. Harp's Tarps sells both: the LSA style with no flaps and the AS style with 18 in flaps, which it describes as DOT compliant. Carolina's flap tarps use 12 in flaps.

The handbook's 1 ft overlap and New Jersey's 12 in minimum both point the same way: if you haul hot mix on public work, or haul far in cold weather, side and rear coverage is what's asked for. A flat tarp that sits on top of the load leaves the edges of the pile open to wind.

How to size an asphalt tarp

Measure the inside length of the body and the distance between the roller mounts (or arm pivots) before you order. Makers size differently depending on the style:

  • Plain roll tarp, length. Harp's says to buy its no-flap LSA tarp 2 ft longer than the dump bed. Carolina Tarps likewise says to add at least 2 ft to the bed length so some tarp stays wrapped on the roller.
  • Flap tarp, length. Harp's says to buy its AS flap tarp the exact length of the bed.
  • Width. Carolina Tarps says to subtract 2 to 6 in from the width between your roller mounts.
  • Drape tarp on spec work. If you're meeting New Jersey's drape option, the minimum is the body plus 2 ft of width and 4 ft of length.

Worked example: tarping a 16 ft tandem body

Illustrative measurements only; measure your own truck and follow the maker's chart.

  1. Measurements. Inside body length 16 ft. Roller mounts 96 in apart. Body about 7 ft 6 in wide.
  2. Plain roll tarp. Length 16 + 2 = 18 ft. Width 96 in minus 2 to 6 in = 90 to 94 in, so a 7 ft 6 in (90 in) wide tarp. Order 7 ft 6 in × 18 ft.
  3. Flap tarp. Following Harp's rule for flap tarps, the length matches the bed: 16 ft. Width as above.
  4. New Jersey drape option. At least 7.5 + 2 = 9.5 ft wide and 16 + 4 = 20 ft long, 18 oz/yd² or heavier, rated to 400°F, with an airfoil in front of the roll.
  5. What it's protecting. Our how many tons of asphalt calculator turns your area and thickness into tons, and the tons of asphalt in a dump truck guide shows how that splits into loads. Every one of those loads needs the same cover.

Tarp systems and hardware

A tarp needs something to roll it out and hold it down. The simplest setup is a hand-crank roller. The Buyers Products DTR7018S tarp kit pairs a telescoping aluminum roller with a 7 × 18 ft solid vinyl tarp, and its listing says the solid vinyl tarps are rated to 400°F for covering asphalt. Electric side-arm and underbody arm systems do the same job with a switch instead of a crank, which makes it easier to follow a rule like tarping every load right at the plant.

Flaps and drape tarps still need tie-downs along the sides and rear. A pack like the US Cargo Control 21 in EPDM tarp straps (10 straps, 2 in S-hooks, 31.5 in maximum stretch, per the listing) covers a flap tarp's tie points. If your spec sets a maximum spacing, like New Jersey's 5 ft, count your hooks against the length of the bed.

Habits that make a tarp work

  • Tarp at the plant, every load. Not just when it's cold or raining. The handbook notes some agencies require tarps in all weather.
  • Keep air off the load. A tarp that balloons at highway speed lets air under it. Tight tie-downs and, where required, an airfoil fix that.
  • Use the right release agent. The handbook says diesel is no longer allowed as a bed release agent; use a nonpetroleum product from your agency's approved list. See our asphalt release agent guide.
  • Check the mix, not the tarp. Shoot the load with an infrared thermometer such as the Fluke 62 Max (listed range -22 to 932°F) when the tarp comes off. It reads the surface only, so probe the mix if you need a core temperature. Our post on using an infrared thermometer on hot mix covers the limits.
  • Replace damaged tarps. Holes and torn flaps defeat the purpose and, on spec work, can get a truck sent back.

Asphalt tarp FAQ

Can I use a mesh tarp for hot asphalt?

It is a poor choice. Makers such as Pulltarps describe mesh as an open weave that lets air through and recommend it for rock, sand and debris that do not need waterproof or windproof cover. Hot mix needs a solid, heat-rated tarp that keeps wind and rain off the load.

What temperature is an asphalt tarp rated for?

It depends on the product. Pulltarps and Roll-Rite list their urethane-coated asphalt tarps at up to 400°F, while Harp's Tarps and Ramken list their 18 oz vinyl asphalt tarps at up to 300°F. Some agency specs, such as New Jersey's 404.06, call for 400°F.

Do asphalt tarps need side flaps?

Not always; it depends on the job spec. NAPA's Asphalt Paving Handbook recommends at least 1 ft of overlap on the sides and back, and New Jersey's spec allows either flaps that lap down at least 12 in or a heavyweight tarp that drapes the whole load.

What size asphalt tarp do I need?

Measure the bed and the roller mounts. Harp's says to buy a no-flap tarp 2 ft longer than the bed and a flap tarp the exact bed length, and Carolina Tarps says to make the width 2 to 6 in less than the distance between the roller mounts.

The bottom line

An asphalt tarp is a solid, heat-rated cover, not a mesh tarp. Published ratings run from 300°F for some 18 oz vinyl tarps to 400°F for urethane-coated ones, and a strict spec like New Jersey's asks for 400°F, full side and rear coverage, tie-downs every 5 ft and an airfoil. Size a plain roll tarp about 2 ft longer than the bed and a few inches narrower than the roller mounts, tarp every load at the plant, and check the mix temperature when it arrives.

Sources

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.