How Much Asphalt for a 200 Space Parking Lot?
Parking lots are usually planned at around 300 to 350 square feet per stall once aisles are counted. A 200-space lot is about 65,000 square feet; how much asphalt for a 200 space parking lot at a 3-inch pavement is roughly 1,178 tons.
Asphalt tonnage calculator →Tons by thickness
| Asphalt thickness | Tons (at ~325 sq ft/space) |
|---|---|
| 2 in | 785 |
| 3 in | 1,178 |
| 4 in | 1,571 |
| 5 in | 1,964 |
Tons use about 145 lb per cubic foot of compacted hot mix. Use the asphalt calculator with your actual measured area for a firm number.
Related: How Much Asphalt for a 100 Space Parking Lot?
Why per-space area varies
Stall size, aisle width, one-way vs two-way traffic, angled vs 90-degree parking, islands and the entrance all change the area per space. Tight lots may run under 300 square feet per stall; lots with landscaping and wide aisles run well over 350. See parking spaces per acre.
Thickness and base
Light-duty lots commonly use a 2 to 3 inch surface on a compacted stone base; drive lanes and dumpster pads get heavier sections. Local code and soil conditions drive the final design. The asphalt base calculator sizes the stone layer.
Related: How Much Asphalt for a 10 Space Parking Lot?
Finishing the lot
Lots need a cross slope, often around 1 to 2 percent, toward inlets or the edge. Plan striping, wheel stops and ADA spaces before paving so the layout works.
Permits and planning
Before finalizing tons, confirm parking requirements, accessible space counts and drainage rules with the local jurisdiction. Stormwater rules in particular can change the layout or require inlets and detention.
Getting an accurate area
A surveyor’s plan or a scaled site drawing gives the most accurate paved area. Break the lot into rectangles for parking rows and aisles, add the entrance and any extra pads, and then convert to tons at the design thickness.
Waste and yield
Paving crews usually order a bit more than the calculated tons to cover uneven base, handwork around edges and the last partial load. A few percent extra is common. Compaction also matters: tons are based on compacted density, not loose mix in the truck.
Questions people ask
How many tons of asphalt for 200 parking spaces?
About 1,178 tons at 3 inches, assuming about 325 sq ft per space.
How many square feet is a 200-space parking lot?
Roughly 65,000 square feet including aisles.
How thick is parking lot asphalt?
Often 2 to 3 inches for car lots, more for heavy traffic, over a compacted stone base.
How many square feet per parking space?
About 300 to 350 square feet per stall including aisles.
Related guides
- Asphalt Parking Lot Cost: Build the Budget From Square Feet and Tons
- How Thick Is a Parking Lot Asphalt Overlay?
- Cross Slope for a Parking Lot
- How Many Parking Spaces Fit on an Acre of Asphalt?
- How Much Asphalt for a 125 Space Parking Lot?
- How Much Asphalt for a 150 Space Parking Lot?
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.