AsphaltTons.com — asphalt tonnage calculator

How Much Recycled Concrete Aggregate for a 14x25 Driveway?

A 14 by 25 foot driveway is 350 square feet. How much recycled concrete aggregate for a 14x25 driveway depends on depth: at 4 inches it is about 4.32 cubic yards or 5.6 tons. Suppliers usually sell by the ton, so the tonnage is the number to give them.

Volume and tonnage calculator →

The math for a 14x25 driveway

  1. Area: 14 × 25 = 350 sq ft.
  2. Depth in feet: 4 ÷ 12 = 0.333 ft.
  3. Cubic feet: 350 × 0.333 = 116.7 cu ft.
  4. Cubic yards: ÷ 27 = 4.32 yd³.
  5. Tons: × 1.3 = 5.6 tons.

The volume and tonnage calculator does this for any size.

Recycled concrete aggregate needed by depth

DepthCubic yardsTons (approx.)Tons +10%
3 in3.244.24.6
4 in4.325.66.2
6 in6.488.49.3

About recycled concrete aggregate

Recycled concrete aggregate is crushed old concrete. It compacts well and often costs less than virgin stone, which makes it a common driveway and pad base. If the yard sells by the cubic yard instead of the ton, use the cubic-yard column directly.

Preparing the driveway

Strip sod and soft topsoil, grade for drainage and compact the subgrade before any stone goes down. Gravel drives last longer with a compacted base layer under the top stone and a slight crown so water runs off. For car and truck traffic, the depths in the table above are a reasonable starting range.

Ordering tips

  • Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
  • Delivery size. 6.2 tons fits in a single typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
  • Bulk vs bags. At this size bulk delivery is usually the practical choice.
  • Where it drops. Have the truck dump as close to the driveway as firm ground allows.

Good and poor uses for recycled concrete aggregate

Good uses:

  • Driveway and pad bases
  • Temporary construction entrances
  • Fill under slabs when compacted in lifts

Poor fit for:

  • Near ponds, streams or sensitive plants, since fresh crush can raise pH
  • Decorative top layers
  • Drainage layers, unless the product is clean and screened

Quick reference numbers

  • Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
  • Per inch over 1,000 sq ft: about 4.0 tons.
  • Another size for comparison: a 14x28 area at 3 inches takes about 4.7 tons.
  • Weight used here: about 1.3 tons per cubic yard.

Common estimating mistakes

  • Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
  • Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
  • Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
  • Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.

Questions people ask

How many tons of recycled concrete aggregate for a 14x25 driveway?

About 5.6 tons at 4 inches deep, or 6.2 tons with 10 percent extra.

How many cubic yards is a 14x25 driveway at 4 inches?

About 4.32 cubic yards.

How much does a cubic yard of recycled concrete aggregate weigh?

Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.

How deep should recycled concrete aggregate be for a driveway?

The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.

How many square feet is 14x25?

350 square feet.

Related guides

Open the volume and tonnage calculator → Asphalt tonnage calculator →

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.