Recycled Concrete Aggregate for a 14x36 Parking Pad
A 14 by 36 foot parking pad is 504 square feet. How much recycled concrete aggregate for a 14x36 parking pad depends on depth: at 4 inches it is about 6.22 cubic yards or 8.1 tons. Suppliers usually sell by the ton, so the tonnage is the number to give them.
Volume and tonnage calculator →The math for a 14x36 parking pad
- Area: 14 × 36 = 504 sq ft.
- Depth in feet: 4 ÷ 12 = 0.333 ft.
- Cubic feet: 504 × 0.333 = 168.0 cu ft.
- Cubic yards: ÷ 27 = 6.22 yd³.
- Tons: × 1.3 = 8.1 tons.
The volume and tonnage calculator does this for any size.
Recycled concrete aggregate needed by depth
| Depth | Cubic yards | Tons (approx.) | Tons +10% |
|---|---|---|---|
| 3 in | 4.67 | 6.1 | 6.7 |
| 4 in | 6.22 | 8.1 | 8.9 |
| 6 in | 9.33 | 12.1 | 13.3 |
About recycled concrete aggregate
Recycled concrete aggregate is crushed old concrete. It compacts well and often costs less than virgin stone, which makes it a common driveway and pad base. Weight per yard is a planning number; the scale ticket at the yard is the real one.
Preparing the parking pad
Dig out organic soil, compact the subgrade and set an edge so the stone does not migrate onto the lawn. A pad that holds parked weight for long periods benefits from a dense base under the surface stone. For parked vehicles, the depths in the table above are a reasonable starting range.
Ordering tips
- Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
- Delivery size. 8.9 tons fits in a single typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
- Bulk vs bags. At this size bulk delivery is usually the practical choice.
- Where it drops. Have the truck dump as close to the parking pad as firm ground allows.
When to choose recycled concrete aggregate
Good uses:
- Driveway and pad bases
- Temporary construction entrances
- Fill under slabs when compacted in lifts
Less suited to:
- Near ponds, streams or sensitive plants, since fresh crush can raise pH
- Decorative top layers
- Drainage layers, unless the product is clean and screened
Quick reference numbers
- Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.0 tons.
- Another size for comparison: a 14x28 area at 4 inches takes about 6.3 tons.
- Weight used here: about 1.3 tons per cubic yard.
Common estimating mistakes
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Questions people ask
How many tons of recycled concrete aggregate for a 14x36 parking pad?
About 8.1 tons at 4 inches deep, or 8.9 tons with 10 percent extra.
How many cubic yards is a 14x36 parking pad at 4 inches?
About 6.22 cubic yards.
How much does a cubic yard of recycled concrete aggregate weigh?
Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.
How deep should recycled concrete aggregate be for a parking pad?
The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.
How many square feet is 14x36?
504 square feet.
Related guides
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- How Much Does a Ton of Gravel Cover? Depth Chart
- Recycled Concrete Aggregate for a 14x24 Parking Pad
- Recycled Concrete Aggregate for a 14x30 Parking Pad
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.