How Much Recycled Concrete Aggregate for a 16x24 Shed Base?
How much recycled concrete aggregate for a 16x24 shed base is a quick volume problem. 384 square feet at 4 inches comes to 4.74 cubic yards. Recycled concrete aggregate usually weighs about 1.2 to 1.4 tons per cubic yard, so plan on roughly 6.2 tons.
Volume and tonnage calculator →The math for a 16x24 shed base
- Area: 16 × 24 = 384 sq ft.
- Depth in feet: 4 ÷ 12 = 0.333 ft.
- Cubic feet: 384 × 0.333 = 128.0 cu ft.
- Cubic yards: ÷ 27 = 4.74 yd³.
- Tons: × 1.3 = 6.2 tons.
The volume and tonnage calculator does this for any size.
Recycled concrete aggregate needed by depth
| Depth | Cubic yards | Tons (approx.) | Tons +10% |
|---|---|---|---|
| 3 in | 3.56 | 4.6 | 5.1 |
| 4 in | 4.74 | 6.2 | 6.8 |
| 6 in | 7.11 | 9.2 | 10.2 |
About recycled concrete aggregate
Ask whether the recycled concrete has been screened for rebar and debris. Fresh-crushed concrete can also be alkaline, so keep it away from sensitive plantings and streams. Ask your supplier for their own tons-per-yard figure, since stone source and moisture shift it.
Preparing the shed base
Level the footprint, extend the stone a foot or so beyond the shed walls for drip and drainage, and compact in lifts. A timber or block border holds the pad shape. For a shed floor frame, the depths in the table above are a reasonable starting range.
Ordering tips
- Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
- Delivery size. 6.8 tons fits in a single typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
- Bulk vs bags. At this size bulk delivery is usually the practical choice.
- Where it drops. Have the truck dump as close to the shed base as firm ground allows.
Where recycled concrete aggregate fits
Good uses:
- Driveway and pad bases
- Temporary construction entrances
- Fill under slabs when compacted in lifts
Think twice for:
- Near ponds, streams or sensitive plants, since fresh crush can raise pH
- Decorative top layers
- Drainage layers, unless the product is clean and screened
Quick reference numbers
- Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.0 tons.
- Another size for comparison: a 12x24 area at 3 inches takes about 3.5 tons.
- Weight used here: about 1.3 tons per cubic yard.
Mistakes that throw off the order
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Questions people ask
How many tons of recycled concrete aggregate for a 16x24 shed base?
About 6.2 tons at 4 inches deep, or 6.8 tons with 10 percent extra.
How many cubic yards is a 16x24 shed base at 4 inches?
About 4.74 cubic yards.
How much does a cubic yard of recycled concrete aggregate weigh?
Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.
How deep should recycled concrete aggregate be for a shed base?
The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.
How many square feet is 16x24?
384 square feet.
Related guides
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- How Much Does a Ton of Gravel Cover? Depth Chart
- How Much Recycled Concrete Aggregate for a 16x16 Shed Base?
- How Much Recycled Concrete Aggregate for a 16x20 Shed Base?
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.