AsphaltTons.com — asphalt tonnage calculator

How Much Recycled Concrete Aggregate for a 18x150 Driveway?

A 18 by 150 foot driveway is 2,700 square feet. How much recycled concrete aggregate for a 18x150 driveway depends on depth: at 4 inches it is about 33.33 cubic yards or 43.3 tons. Suppliers usually sell by the ton, so the tonnage is the number to give them.

Volume and tonnage calculator →

The math for a 18x150 driveway

  1. Area: 18 × 150 = 2,700 sq ft.
  2. Depth in feet: 4 ÷ 12 = 0.333 ft.
  3. Cubic feet: 2,700 × 0.333 = 900.0 cu ft.
  4. Cubic yards: ÷ 27 = 33.33 yd³.
  5. Tons: × 1.3 = 43.3 tons.

The volume and tonnage calculator does this for any size.

Recycled concrete aggregate needed by depth

DepthCubic yardsTons (approx.)Tons +10%
3 in25.0032.535.8
4 in33.3343.347.7
6 in50.0065.071.5

About recycled concrete aggregate

Ask whether the recycled concrete has been screened for rebar and debris. Fresh-crushed concrete can also be alkaline, so keep it away from sensitive plantings and streams. Ask your supplier for their own tons-per-yard figure, since stone source and moisture shift it.

Preparing the driveway

Strip sod and soft topsoil, grade for drainage and compact the subgrade before any stone goes down. Gravel drives last longer with a compacted base layer under the top stone and a slight crown so water runs off. Since the driveway carries car and truck traffic, a little extra depth is cheap insurance.

Ordering tips

  • Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
  • Delivery size. 47.7 tons may take more than one typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
  • Bulk vs bags. At this size bulk delivery is usually the practical choice.
  • Where it drops. Have the truck dump as close to the driveway as firm ground allows.

When to choose recycled concrete aggregate

Works well for:

  • Driveway and pad bases
  • Temporary construction entrances
  • Fill under slabs when compacted in lifts

Think twice for:

  • Near ponds, streams or sensitive plants, since fresh crush can raise pH
  • Decorative top layers
  • Drainage layers, unless the product is clean and screened

Quick reference numbers

  • Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
  • Per inch over 1,000 sq ft: about 4.0 tons.
  • Another size for comparison: a 12x24 area at 4 inches takes about 4.6 tons.
  • Weight used here: about 1.3 tons per cubic yard.

Mistakes that throw off the order

  • Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
  • Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
  • Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
  • Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.

Questions people ask

How many tons of recycled concrete aggregate for a 18x150 driveway?

About 43.3 tons at 4 inches deep, or 47.7 tons with 10 percent extra.

How many cubic yards is a 18x150 driveway at 4 inches?

About 33.33 cubic yards.

How much does a cubic yard of recycled concrete aggregate weigh?

Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.

How deep should recycled concrete aggregate be for a driveway?

The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.

How many square feet is 18x150?

2,700 square feet.

Related guides

Open the volume and tonnage calculator → Asphalt tonnage calculator →

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.