How Much Recycled Concrete Aggregate for a 18x80 Driveway?

How much recycled concrete aggregate for a 18x80 driveway: at 4 inches deep you need about 17.78 cubic yards, which is roughly 23.1 tons at 1.3 tons per yard. The driveway covers 1,440 square feet, so every inch of depth adds about 4.44 yards.

Volume and tonnage calculator →

The math for a 18x80 driveway

Area: 18 × 80 = 1,440 sq ft.
Depth in feet: 4 ÷ 12 = 0.333 ft.
Cubic feet: 1,440 × 0.333 = 480.0 cu ft.
Cubic yards: ÷ 27 = 17.78 yd³.
Tons: × 1.3 = 23.1 tons.

The volume and tonnage calculator does this for any size.

Recycled concrete aggregate needed by depth

Depth	Cubic yards	Tons (approx.)	Tons +10%
3 in	13.33	17.3	19.1
4 in	17.78	23.1	25.4
6 in	26.67	34.7	38.1

About recycled concrete aggregate

Recycled concrete aggregate is crushed old concrete. It compacts well and often costs less than virgin stone, which makes it a common driveway and pad base. Ask your supplier for their own tons-per-yard figure, since stone source and moisture shift it.

Preparing the driveway

Strip sod and soft topsoil, grade for drainage and compact the subgrade before any stone goes down. Gravel drives last longer with a compacted base layer under the top stone and a slight crown so water runs off. This driveway sees car and truck traffic, so match the depth to that load rather than to the minimum.

Ordering tips

Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
Delivery size. 25.4 tons may take more than one typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
Bulk vs bags. At this size bulk delivery is usually the practical choice.
Where it drops. Have the truck dump as close to the driveway as firm ground allows.

When to choose recycled concrete aggregate

Best suited to:

Driveway and pad bases
Temporary construction entrances
Fill under slabs when compacted in lifts

Less suited to:

Near ponds, streams or sensitive plants, since fresh crush can raise pH
Decorative top layers
Drainage layers, unless the product is clean and screened

Quick reference numbers

Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
Per inch over 1,000 sq ft: about 4.0 tons.
Another size for comparison: a 10x20 area at 2 inches takes about 1.6 tons.
Weight used here: about 1.3 tons per cubic yard.

Mistakes that throw off the order

Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.

Questions people ask

How many tons of recycled concrete aggregate for a 18x80 driveway?

About 23.1 tons at 4 inches deep, or 25.4 tons with 10 percent extra.

How many cubic yards is a 18x80 driveway at 4 inches?

About 17.78 cubic yards.

How much does a cubic yard of recycled concrete aggregate weigh?

Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.

How deep should recycled concrete aggregate be for a driveway?

The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.

How many square feet is 18x80?

1,440 square feet.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.