Recycled Concrete Aggregate for a 20x50 Parking Pad

A 20 by 50 foot parking pad is 1,000 square feet. How much recycled concrete aggregate for a 20x50 parking pad depends on depth: at 4 inches it is about 12.35 cubic yards or 16.0 tons. Suppliers usually sell by the ton, so the tonnage is the number to give them.

Volume and tonnage calculator →

The math for a 20x50 parking pad

Area: 20 × 50 = 1,000 sq ft.
Depth in feet: 4 ÷ 12 = 0.333 ft.
Cubic feet: 1,000 × 0.333 = 333.3 cu ft.
Cubic yards: ÷ 27 = 12.35 yd³.
Tons: × 1.3 = 16.0 tons.

The volume and tonnage calculator does this for any size.

Recycled concrete aggregate needed by depth

Depth	Cubic yards	Tons (approx.)	Tons +10%
3 in	9.26	12.0	13.2
4 in	12.35	16.0	17.7
6 in	18.52	24.1	26.5

About recycled concrete aggregate

Ask whether the recycled concrete has been screened for rebar and debris. Fresh-crushed concrete can also be alkaline, so keep it away from sensitive plantings and streams. Ask your supplier for their own tons-per-yard figure, since stone source and moisture shift it.

Preparing the parking pad

Dig out organic soil, compact the subgrade and set an edge so the stone does not migrate onto the lawn. A pad that holds parked weight for long periods benefits from a dense base under the surface stone. Since the parking pad carries parked vehicles, a little extra depth is cheap insurance.

Ordering tips

Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
Delivery size. 17.7 tons may take more than one typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
Bulk vs bags. At this size bulk delivery is usually the practical choice.
Where it drops. Have the truck dump as close to the parking pad as firm ground allows.

When to choose recycled concrete aggregate

Works well for:

Driveway and pad bases
Temporary construction entrances
Fill under slabs when compacted in lifts

Poor fit for:

Near ponds, streams or sensitive plants, since fresh crush can raise pH
Decorative top layers
Drainage layers, unless the product is clean and screened

Quick reference numbers

Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
Per inch over 1,000 sq ft: about 4.0 tons.
Another size for comparison: a 15x30 area at 2 inches takes about 3.6 tons.
Weight used here: about 1.3 tons per cubic yard.

Mistakes that throw off the order

Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.

Questions people ask

How many tons of recycled concrete aggregate for a 20x50 parking pad?

About 16.0 tons at 4 inches deep, or 17.7 tons with 10 percent extra.

How many cubic yards is a 20x50 parking pad at 4 inches?

About 12.35 cubic yards.

How much does a cubic yard of recycled concrete aggregate weigh?

Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.

How deep should recycled concrete aggregate be for a parking pad?

The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.

How many square feet is 20x50?

1,000 square feet.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.