How Much Recycled Concrete Aggregate for a 22x50 Driveway?

A 22 by 50 foot driveway is 1,100 square feet. How much recycled concrete aggregate for a 22x50 driveway depends on depth: at 4 inches it is about 13.58 cubic yards or 17.7 tons. Suppliers usually sell by the ton, so the tonnage is the number to give them.

Volume and tonnage calculator →

The math for a 22x50 driveway

Area: 22 × 50 = 1,100 sq ft.
Depth in feet: 4 ÷ 12 = 0.333 ft.
Cubic feet: 1,100 × 0.333 = 366.7 cu ft.
Cubic yards: ÷ 27 = 13.58 yd³.
Tons: × 1.3 = 17.7 tons.

The volume and tonnage calculator does this for any size.

Recycled concrete aggregate needed by depth

Depth	Cubic yards	Tons (approx.)	Tons +10%
3 in	10.19	13.2	14.6
4 in	13.58	17.7	19.4
6 in	20.37	26.5	29.1

About recycled concrete aggregate

Ask whether the recycled concrete has been screened for rebar and debris. Fresh-crushed concrete can also be alkaline, so keep it away from sensitive plantings and streams. Weight per yard is a planning number; the scale ticket at the yard is the real one.

Preparing the driveway

Strip sod and soft topsoil, grade for drainage and compact the subgrade before any stone goes down. Gravel drives last longer with a compacted base layer under the top stone and a slight crown so water runs off. This driveway sees car and truck traffic, so match the depth to that load rather than to the minimum.

Ordering tips

Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
Delivery size. 19.4 tons may take more than one typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
Bulk vs bags. At this size bulk delivery is usually the practical choice.
Where it drops. Have the truck dump as close to the driveway as firm ground allows.

Where recycled concrete aggregate fits

Good uses:

Driveway and pad bases
Temporary construction entrances
Fill under slabs when compacted in lifts

Think twice for:

Near ponds, streams or sensitive plants, since fresh crush can raise pH
Decorative top layers
Drainage layers, unless the product is clean and screened

Quick reference numbers

Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
Per inch over 1,000 sq ft: about 4.0 tons.
Another size for comparison: a 15x30 area at 4 inches takes about 7.2 tons.
Weight used here: about 1.3 tons per cubic yard.

Mistakes that throw off the order

Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.

Questions people ask

How many tons of recycled concrete aggregate for a 22x50 driveway?

About 17.7 tons at 4 inches deep, or 19.4 tons with 10 percent extra.

How many cubic yards is a 22x50 driveway at 4 inches?

About 13.58 cubic yards.

How much does a cubic yard of recycled concrete aggregate weigh?

Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.

How deep should recycled concrete aggregate be for a driveway?

The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.

How many square feet is 22x50?

1,100 square feet.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.