Recycled Concrete Aggregate for a 30x30 Parking Pad

How much recycled concrete aggregate for a 30x30 parking pad: at 4 inches deep you need about 11.11 cubic yards, which is roughly 14.4 tons at 1.3 tons per yard. The parking pad covers 900 square feet, so every inch of depth adds about 2.78 yards.

Volume and tonnage calculator →

The math for a 30x30 parking pad

Area: 30 × 30 = 900 sq ft.
Depth in feet: 4 ÷ 12 = 0.333 ft.
Cubic feet: 900 × 0.333 = 300.0 cu ft.
Cubic yards: ÷ 27 = 11.11 yd³.
Tons: × 1.3 = 14.4 tons.

The volume and tonnage calculator does this for any size.

Recycled concrete aggregate needed by depth

Depth	Cubic yards	Tons (approx.)	Tons +10%
3 in	8.33	10.8	11.9
4 in	11.11	14.4	15.9
6 in	16.67	21.7	23.8

About recycled concrete aggregate

Ask whether the recycled concrete has been screened for rebar and debris. Fresh-crushed concrete can also be alkaline, so keep it away from sensitive plantings and streams. Weight per yard is a planning number; the scale ticket at the yard is the real one.

Preparing the parking pad

Dig out organic soil, compact the subgrade and set an edge so the stone does not migrate onto the lawn. A pad that holds parked weight for long periods benefits from a dense base under the surface stone. For parked vehicles, the depths in the table above are a reasonable starting range.

Ordering tips

Round up. Compaction and uneven ground eat material. Adding about 10 percent is common.
Delivery size. 15.9 tons may take more than one typical dump truck load; small loads may carry a delivery fee. See how many tons of gravel in a dump truck.
Bulk vs bags. At this size bulk delivery is usually the practical choice.
Where it drops. Have the truck dump as close to the parking pad as firm ground allows.

When to choose recycled concrete aggregate

Best suited to:

Driveway and pad bases
Temporary construction entrances
Fill under slabs when compacted in lifts

Think twice for:

Near ponds, streams or sensitive plants, since fresh crush can raise pH
Decorative top layers
Drainage layers, unless the product is clean and screened

Quick reference numbers

Per inch over 100 sq ft: about 0.40 tons of recycled concrete aggregate (0.31 cubic yards).
Per inch over 1,000 sq ft: about 4.0 tons.
Another size for comparison: a 12x24 area at 4 inches takes about 4.6 tons.
Weight used here: about 1.3 tons per cubic yard.

Mistakes that throw off the order

Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.

Questions people ask

How many tons of recycled concrete aggregate for a 30x30 parking pad?

About 14.4 tons at 4 inches deep, or 15.9 tons with 10 percent extra.

How many cubic yards is a 30x30 parking pad at 4 inches?

About 11.11 cubic yards.

How much does a cubic yard of recycled concrete aggregate weigh?

Usually around 1.2 to 1.4 tons, depending on stone size, fines and moisture.

How deep should recycled concrete aggregate be for a parking pad?

The table above shows 3 to 6 inches. Shallower depths suit top dressing; deeper depths suit new installs and heavier use.

How many square feet is 30x30?

900 square feet.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.