Tons of Asphalt Millings per 100 Feet of 22 ft Road
Tons of asphalt millings per 100 feet of 22 foot road: about 35 tons at 4 inches deep. The strip is 22 ft × 100 ft = 2,200 square feet. Shoulders, pullouts and turnarounds add to the total; measure them separately.
Volume and tonnage calculator →Tons by depth
| Depth | Tons | Truckloads (~14 t) |
|---|---|---|
| 3 in | 26 | 2 |
| 4 in | 35 | 3 |
| 6 in | 53 | 4 |
| 8 in | 71 | 6 |
The math
- Area: 22 × 100 = 2,200 sq ft.
- Volume at 4 in: 2,200 × 0.333 = 733 cu ft (27 cubic yards).
- × 1.3 tons per yard = 35 tons.
What goes into the section
At 22 feet wide, this is a two-lane road width. Asphalt millings are ground-up old pavement. When compacted and warmed by sun they bind into a fairly firm surface, which is why they are popular for rural drives and lots. Crown the surface so water sheds to ditches on both sides.
Practical notes
- Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
- Waste. Allow 5 to 10 percent.
- Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.
Check other sizes with the volume and tonnage calculator.
Where asphalt millings fits
Good uses:
- Rural driveways and farm lanes
- Parking areas where a dust-free surface is wanted
- Low-cost base under a future paved surface
Less suited to:
- Areas near wells or streams where local rules limit them
- Decorative or barefoot areas
- Jobs needing a uniform, clean look
Quick reference numbers
- Per inch over 100 sq ft: about 0.40 tons of asphalt millings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.0 tons.
- Another size for comparison: a 10x20 area at 4 inches takes about 3.2 tons.
- Weight used here: about 1.3 tons per cubic yard.
Common estimating mistakes
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Questions people ask
How many tons of asphalt millings per 100 feet of 22 ft road?
About 35 tons at 4 inches.
How many truckloads is that?
About 3 loads at roughly 14 tons each.
How many square feet is 100 feet of 22 ft road?
2,200 square feet.
Should I add extra for waste?
Yes, 5 to 10 percent is common.
Does this include the shoulders?
No. Measure shoulders and pullouts separately and add them.
Related guides
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- Asphalt Hauling Cost Per Ton: What Drives the Delivered Price
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons of Asphalt Millings per 100 Feet of 20 ft Road
- Tons of Asphalt Millings per Mile of 22 ft Road
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.