14 Cubic Yards of Limestone Screenings in Tons
14 cubic yards of limestone screenings in tons works out to about 19.6 tons using a planning weight of 1.4 tons per yard. Real loads land between roughly 18.2 and 21.0 tons depending on stone size, fines and moisture. That is about 39,200 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 14 × 1.4 = 19.6 tons.
- Low end: 14 × 1.3 = 18.2 tons.
- High end: 14 × 1.5 = 21.0 tons.
The scale ticket on delivery day is the final word on weight.
What 14 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 4,536 |
| 2 in | 2,268 |
| 3 in | 1,512 |
About limestone screenings
Limestone screenings are the fine dust and chips left after crushing limestone. They pack very tight, which makes them a common setting bed for pavers and flagstone and a surface for paths.
Hauling 14 yards
At about 19.6 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices limestone screenings by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
When to choose limestone screenings
Good uses:
- Paver and flagstone setting beds
- Firm walking paths
- Top-dressing a compacted stone base
Less suited to:
- Deep layers on their own
- Low spots that collect water
- Under heavy vehicle traffic without a base
Quick reference numbers
- Per inch over 100 sq ft: about 0.43 tons of limestone screenings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.3 tons.
- Another size for comparison: a 20x25 area at 2 inches takes about 4.3 tons.
- Weight used here: about 1.4 tons per cubic yard.
Where estimates go wrong
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
Questions people ask
How many tons is 14 yards of limestone screenings?
About 19.6 tons, with a typical range of 18.2 to 21.0.
How many pounds is 14 cubic yards of limestone screenings?
About 39,200 pounds.
How much area does 14 yards of limestone screenings cover at 2 inches?
About 2,268 square feet.
Why does limestone screenings weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- #10 Stone (Stone Dust): Size, Uses and How Many Tons
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 12 Cubic Yards of Limestone Screenings in Tons
- 13 Cubic Yards of Limestone Screenings in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.