2 Cubic Yards of Crusher Run in Tons
2 cubic yards of crusher run in tons works out to about 3.1 tons using a planning weight of 1.55 tons per yard. Real loads land between roughly 3.0 and 3.4 tons depending on stone size, fines and moisture. That is about 6,200 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 2 × 1.55 = 3.1 tons.
- Low end: 2 × 1.5 = 3.0 tons.
- High end: 2 × 1.7 = 3.4 tons.
The scale ticket on delivery day is the final word on weight.
What 2 yards covers
| Depth | Square feet |
|---|---|
| 3 in | 216 |
| 4 in | 162 |
| 6 in | 108 |
| 8 in | 81 |
About crusher run
The fines in crusher run fill the gaps between stones, so it weighs more per yard than clean stone once compacted. Plan on rolling or plate-compacting it in lifts.
Hauling 2 yards
At about 3.1 tons, this is a load most single-axle dump trucks can take. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices crusher run by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
When to choose crusher run
Works well for:
- Base under asphalt, pavers or concrete
- Gravel drives that need a firm, packed surface
- Shed pads and equipment pads
Less suited to:
- Drainage layers, since the fines slow water
- Decorative beds
- Spots where you want water to soak straight through
Quick reference numbers
- Per inch over 100 sq ft: about 0.48 tons of crusher run (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.8 tons.
- Another size for comparison: a 15x30 area at 2 inches takes about 4.3 tons.
- Weight used here: about 1.55 tons per cubic yard.
Mistakes that throw off the order
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
- Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
Questions people ask
How many tons is 2 yards of crusher run?
About 3.1 tons, with a typical range of 3.0 to 3.4.
How many pounds is 2 cubic yards of crusher run?
About 6,200 pounds.
How much area does 2 yards of crusher run cover at 6 inches?
About 108 square feet.
Why does crusher run weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.