8 Cubic Yards of Limestone Screenings in Tons
8 cubic yards of limestone screenings in tons works out to about 11.2 tons using a planning weight of 1.4 tons per yard. Real loads land between roughly 10.4 and 12.0 tons depending on stone size, fines and moisture. That is about 22,400 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 8 × 1.4 = 11.2 tons.
- Low end: 8 × 1.3 = 10.4 tons.
- High end: 8 × 1.5 = 12.0 tons.
If your supplier quotes a different weight per yard, multiply by theirs.
What 8 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 2,592 |
| 2 in | 1,296 |
| 3 in | 864 |
About limestone screenings
Limestone screenings are the fine dust and chips left after crushing limestone. They pack very tight, which makes them a common setting bed for pavers and flagstone and a surface for paths.
Hauling 8 yards
Plan the delivery around 11.2 tons: one tandem in most areas. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices limestone screenings by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Good and poor uses for limestone screenings
Works well for:
- Paver and flagstone setting beds
- Firm walking paths
- Top-dressing a compacted stone base
Less suited to:
- Deep layers on their own
- Low spots that collect water
- Under heavy vehicle traffic without a base
Quick reference numbers
- Per inch over 100 sq ft: about 0.43 tons of limestone screenings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.3 tons.
- Another size for comparison: a 10x20 area at 2 inches takes about 1.7 tons.
- Weight used here: about 1.4 tons per cubic yard.
Common estimating mistakes
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
Questions people ask
How many tons is 8 yards of limestone screenings?
About 11.2 tons, with a typical range of 10.4 to 12.0.
How many pounds is 8 cubic yards of limestone screenings?
About 22,400 pounds.
How much area does 8 yards of limestone screenings cover at 2 inches?
About 1,296 square feet.
Why does limestone screenings weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- #10 Stone (Stone Dust): Size, Uses and How Many Tons
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 6 Cubic Yards of Limestone Screenings in Tons
- 7 Cubic Yards of Limestone Screenings in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.