Tons of Asphalt for 100,000 Square Feet

Tons of asphalt for 100,000 square feet: about 1,208.3 tons at 2 inches compacted and about 1,812.5 tons at 3 inches, figured at roughly 145 pounds per cubic foot. That is 11,111 square yards of pavement.

Asphalt tonnage calculator →

Tons by thickness

Thickness	Tons	Tons +5%
1.5 in	906.2	951.6
2 in	1,208.3	1,268.8
2.5 in	1,510.4	1,585.9
3 in	1,812.5	1,903.1
4 in	2,416.7	2,537.5

How the numbers are built

100,000 sq ft × (2 ÷ 12) ft = 16,667 cubic feet at 2 inches.
× 145 lb = 2,416,667 lb.
÷ 2,000 = 1,208.3 tons.

Rule of thumb: roughly 6 tons per 1,000 square feet for every inch of thickness. See tons of asphalt per 1,000 square feet.

What size job this is

This is commercial scale: a parking lot, a long private road or a large apron. Bigger areas tend to be paved in two lifts, which changes how the tons split between mixes.

Trucks and ordering

At 3 inches, 1,812.5 tons is about 136 truckloads at around 14 tons each. Plants set minimum orders and charge for hauling; see asphalt hauling cost per ton.

Things that move the total

Mix density typically runs 140 to 150 lb per cubic foot.
Base condition: dips and ruts fill with extra mix.
Waste of 5 to 10 percent is a common allowance.

Run exact numbers with the asphalt tonnage calculator.

Where asphalt fits

Best suited to:

Driveways, parking pads and private lanes that need a smooth, sealed surface
Overlays on old pavement that is cracked but still structurally sound
Areas where snow will be plowed, since a paved surface does not throw stone

Poor fit for:

Ground that stays soft or wet, unless the base and drainage are fixed first
Very small patches, where bagged cold patch is often simpler
Jobs in cold weather, since hot mix needs warm temperatures to compact properly

Quick reference numbers

Per inch over 100 sq ft: about 0.62 tons of asphalt (0.31 cubic yards).
Per inch over 1,000 sq ft: about 6.2 tons.
Another size for comparison: a 8x16 area at 2 inches takes about 1.6 tons.
Weight used here: about 2.0 tons per cubic yard (roughly 145 lb per compacted cubic foot).

Mistakes that throw off the order

Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.

Questions people ask

How many tons of asphalt for 100,000 square feet at 2 inches?

About 1,208.3 tons.

How many tons for 100,000 square feet at 3 inches?

About 1,812.5 tons.

How many square yards is 100,000 square feet?

About 11,111 square yards.

What density is used here?

145 lb per compacted cubic foot, a common planning figure.

Should I add extra?

Most estimators add 5 to 10 percent for waste and uneven base.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.