Tons of Asphalt for 60,000 Square Feet

Tons of asphalt for 60,000 square feet: about 725.0 tons at 2 inches compacted and about 1,087.5 tons at 3 inches, figured at roughly 145 pounds per cubic foot. That is 6,667 square yards of pavement.

Asphalt tonnage calculator →

Tons by thickness

Thickness	Tons	Tons +5%
1.5 in	543.8	570.9
2 in	725.0	761.2
2.5 in	906.2	951.6
3 in	1,087.5	1,141.9
4 in	1,450.0	1,522.5

How the numbers are built

60,000 sq ft × (2 ÷ 12) ft = 10,000 cubic feet at 2 inches.
× 145 lb = 1,450,000 lb.
÷ 2,000 = 725.0 tons.

A shortcut: each inch of compacted asphalt over 1,000 square feet weighs about 6 tons. See tons of asphalt per 1,000 square feet.

How big 60,000 square feet is

This is commercial scale: a parking lot, a long private road or a large apron. The bigger the area, the more a small change in thickness swings the total tons.

Trucks and ordering

At 3 inches, 1,087.5 tons is about 82 truckloads at around 14 tons each. Plants set minimum orders and charge for hauling; see asphalt hauling cost per ton.

Things that move the total

Mix density typically runs 140 to 150 lb per cubic foot.
Base condition: dips and ruts fill with extra mix.
Waste of 5 to 10 percent is a common allowance.

Run exact numbers with the asphalt tonnage calculator.

When to choose asphalt

Best suited to:

Driveways, parking pads and private lanes that need a smooth, sealed surface
Overlays on old pavement that is cracked but still structurally sound
Areas where snow will be plowed, since a paved surface does not throw stone

Less suited to:

Ground that stays soft or wet, unless the base and drainage are fixed first
Very small patches, where bagged cold patch is often simpler
Jobs in cold weather, since hot mix needs warm temperatures to compact properly

Quick reference numbers

Per inch over 100 sq ft: about 0.62 tons of asphalt (0.31 cubic yards).
Per inch over 1,000 sq ft: about 6.2 tons.
Another size for comparison: a 14x28 area at 3 inches takes about 7.3 tons.
Weight used here: about 2.0 tons per cubic yard (roughly 145 lb per compacted cubic foot).

Common estimating mistakes

Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.

Questions people ask

How many tons of asphalt for 60,000 square feet at 2 inches?

About 725.0 tons.

How many tons for 60,000 square feet at 3 inches?

About 1,087.5 tons.

How many square yards is 60,000 square feet?

About 6,667 square yards.

What density is used here?

145 lb per compacted cubic foot, a common planning figure.

Should I add extra?

Most estimators add 5 to 10 percent for waste and uneven base.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.