Tons of Asphalt for 14,000 Square Feet

Tons of asphalt for 14,000 square feet: about 169.2 tons at 2 inches compacted and about 253.8 tons at 3 inches, figured at roughly 145 pounds per cubic foot. That is 1,556 square yards of pavement.

Asphalt tonnage calculator →

Tons by thickness

Thickness	Tons	Tons +5%
1.5 in	126.9	133.2
2 in	169.2	177.6
2.5 in	211.5	222.0
3 in	253.8	266.4
4 in	338.3	355.3

How the numbers are built

14,000 sq ft × (2 ÷ 12) ft = 2,333 cubic feet at 2 inches.
× 145 lb = 338,333 lb.
÷ 2,000 = 169.2 tons.

Quick check: about 0.006 tons per square foot per inch. See tons of asphalt per 1,000 square feet.

How big 14,000 square feet is

This is commercial scale: a parking lot, a long private road or a large apron. The bigger the area, the more a small change in thickness swings the total tons.

Trucks and ordering

At 3 inches, 253.8 tons is about 20 truckloads at around 14 tons each. Plants set minimum orders and charge for hauling; see asphalt hauling cost per ton.

Things that move the total

Mix density typically runs 140 to 150 lb per cubic foot.
Base condition: dips and ruts fill with extra mix.
Waste of 5 to 10 percent is a common allowance.

Run exact numbers with the asphalt tonnage calculator.

Good and poor uses for asphalt

Best suited to:

Driveways, parking pads and private lanes that need a smooth, sealed surface
Overlays on old pavement that is cracked but still structurally sound
Areas where snow will be plowed, since a paved surface does not throw stone

Poor fit for:

Ground that stays soft or wet, unless the base and drainage are fixed first
Very small patches, where bagged cold patch is often simpler
Jobs in cold weather, since hot mix needs warm temperatures to compact properly

Quick reference numbers

Per inch over 100 sq ft: about 0.62 tons of asphalt (0.31 cubic yards).
Per inch over 1,000 sq ft: about 6.2 tons.
Another size for comparison: a 8x16 area at 4 inches takes about 3.2 tons.
Weight used here: about 2.0 tons per cubic yard (roughly 145 lb per compacted cubic foot).

Where estimates go wrong

Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.

Questions people ask

How many tons of asphalt for 14,000 square feet at 2 inches?

About 169.2 tons.

How many tons for 14,000 square feet at 3 inches?

About 253.8 tons.

How many square yards is 14,000 square feet?

About 1,556 square yards.

What density is used here?

145 lb per compacted cubic foot, a common planning figure.

Should I add extra?

Most estimators add 5 to 10 percent for waste and uneven base.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.