Tons of Asphalt Millings per 100 Feet of 24 ft Road
Tons of asphalt millings per 100 feet of 24 foot road: about 39 tons at 4 inches deep. The strip is 24 ft × 100 ft = 2,400 square feet. On a job this long, half an inch of extra depth adds a lot of tons.
Volume and tonnage calculator →Tons by depth
| Depth | Tons | Truckloads (~14 t) |
|---|---|---|
| 3 in | 29 | 3 |
| 4 in | 39 | 3 |
| 6 in | 58 | 5 |
| 8 in | 77 | 6 |
The math
- Area: 24 × 100 = 2,400 sq ft.
- Volume at 4 in: 2,400 × 0.333 = 800 cu ft (30 cubic yards).
- × 1.3 tons per yard = 39 tons.
What goes into the section
At 24 feet wide, this is a two-lane road width. Asphalt millings are ground-up old pavement. When compacted and warmed by sun they bind into a fairly firm surface, which is why they are popular for rural drives and lots. Crown the surface so water sheds to ditches on both sides.
Practical notes
- Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
- Waste. Allow 5 to 10 percent.
- Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.
Check other sizes with the volume and tonnage calculator.
Where asphalt millings fits
Works well for:
- Rural driveways and farm lanes
- Parking areas where a dust-free surface is wanted
- Low-cost base under a future paved surface
Think twice for:
- Areas near wells or streams where local rules limit them
- Decorative or barefoot areas
- Jobs needing a uniform, clean look
Quick reference numbers
- Per inch over 100 sq ft: about 0.40 tons of asphalt millings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.0 tons.
- Another size for comparison: a 8x16 area at 2 inches takes about 1.0 tons.
- Weight used here: about 1.3 tons per cubic yard.
Mistakes that throw off the order
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
Questions people ask
How many tons of asphalt millings per 100 feet of 24 ft road?
About 39 tons at 4 inches.
How many truckloads is that?
About 3 loads at roughly 14 tons each.
How many square feet is 100 feet of 24 ft road?
2,400 square feet.
Should I add extra for waste?
Yes, 5 to 10 percent is common.
Does this include the shoulders?
No. Measure shoulders and pullouts separately and add them.
Related guides
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- Asphalt Hauling Cost Per Ton: What Drives the Delivered Price
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons of Asphalt Millings per 100 Feet of 22 ft Road
- Tons of Asphalt Millings per Mile of 24 ft Road
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.