Tons of Asphalt per Mile of 22 ft Road

Tons of asphalt per mile of 22 foot road: about 2,105 tons at 3 inches compacted. The strip is 22 ft × 5,280 ft = 116,160 square feet. On a job this long, half an inch of extra depth adds a lot of tons.

Asphalt tonnage calculator →

Tons by depth

Depth	Tons	Truckloads (~14 t)
2 in	1,404	101
3 in	2,105	151
4 in	2,807	201

The math

Area: 22 × 5,280 = 116,160 sq ft.
Volume at 3 in: 116,160 × 0.250 = 29,040 cu ft.
× 145 lb ÷ 2,000 = 2,105 tons.

Building a road this width

A 22-foot width gives two full lanes. Paved roads sit on a compacted aggregate base, ordered separately from the asphalt. Crown the surface so water sheds to ditches on both sides.

Practical notes

Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
Waste. Allow 5 to 10 percent.
Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.

Check other sizes with the asphalt tonnage calculator.

When to choose asphalt

Good uses:

Driveways, parking pads and private lanes that need a smooth, sealed surface
Overlays on old pavement that is cracked but still structurally sound
Areas where snow will be plowed, since a paved surface does not throw stone

Poor fit for:

Ground that stays soft or wet, unless the base and drainage are fixed first
Very small patches, where bagged cold patch is often simpler
Jobs in cold weather, since hot mix needs warm temperatures to compact properly

Quick reference numbers

Per inch over 100 sq ft: about 0.62 tons of asphalt (0.31 cubic yards).
Per inch over 1,000 sq ft: about 6.2 tons.
Another size for comparison: a 14x28 area at 4 inches takes about 9.7 tons.
Weight used here: about 2.0 tons per cubic yard (roughly 145 lb per compacted cubic foot).

Where estimates go wrong

Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.

Questions people ask

How many tons of asphalt per mile of 22 ft road?

About 2,105 tons at 3 inches.

How many truckloads is that?

About 151 loads at roughly 14 tons each.

How many square feet is mile of 22 ft road?

116,160 square feet.

Should I add extra for waste?

Yes, 5 to 10 percent is common.

Does this include the shoulders?

No. Measure shoulders and pullouts separately and add them.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.