Tons of Crusher Run per Mile of 28 ft Road
Tons of crusher run per mile of 28 foot road: about 4,244 tons at 6 inches deep. The strip is 28 ft × 5,280 ft = 147,840 square feet. Long runs magnify small depth changes, so pin the depth down before ordering.
Volume and tonnage calculator →Tons by depth
| Depth | Tons | Truckloads (~14 t) |
|---|---|---|
| 3 in | 2,122 | 152 |
| 4 in | 2,829 | 203 |
| 6 in | 4,244 | 304 |
| 8 in | 5,658 | 405 |
The math
- Area: 28 × 5,280 = 147,840 sq ft.
- Volume at 6 in: 147,840 × 0.500 = 73,920 cu ft (2,738 cubic yards).
- × 1.55 tons per yard = 4,244 tons.
Building a road this width
A 28-foot width gives two full lanes. Crusher run (also sold as crush and run, dense-grade aggregate or QP in some regions) mixes stone with stone dust. It compacts into a firm, nearly solid layer, which makes it the usual base under pavers, asphalt and gravel drives. Crown the surface so water sheds to ditches on both sides.
Practical notes
- Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
- Waste. Allow 5 to 10 percent.
- Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.
Check other sizes with the volume and tonnage calculator.
Where crusher run fits
Best suited to:
- Base under asphalt, pavers or concrete
- Gravel drives that need a firm, packed surface
- Shed pads and equipment pads
Less suited to:
- Drainage layers, since the fines slow water
- Decorative beds
- Spots where you want water to soak straight through
Quick reference numbers
- Per inch over 100 sq ft: about 0.48 tons of crusher run (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.8 tons.
- Another size for comparison: a 20x25 area at 4 inches takes about 9.6 tons.
- Weight used here: about 1.55 tons per cubic yard.
Common estimating mistakes
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
Questions people ask
How many tons of crusher run per mile of 28 ft road?
About 4,244 tons at 6 inches.
How many truckloads is that?
About 304 loads at roughly 14 tons each.
How many square feet is mile of 28 ft road?
147,840 square feet.
Should I add extra for waste?
Yes, 5 to 10 percent is common.
Does this include the shoulders?
No. Measure shoulders and pullouts separately and add them.
Related guides
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- Asphalt Hauling Cost Per Ton: What Drives the Delivered Price
- Crushed Stone vs Gravel: Differences and Best Uses
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.