11 Cubic Yards of Road Base in Tons
11 cubic yards of road base in tons works out to about 16.5 tons using a planning weight of 1.5 tons per yard. Real loads land between roughly 15.4 and 18.1 tons depending on stone size, fines and moisture. That is about 33,000 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 11 × 1.5 = 16.5 tons.
- Low end: 11 × 1.4 = 15.4 tons.
- High end: 11 × 1.65 = 18.1 tons.
Quarries can tell you the weight per yard for their own product; use it if you have it.
What 11 yards covers
| Depth | Square feet |
|---|---|
| 4 in | 891 |
| 6 in | 594 |
| 8 in | 446 |
About road base
Road base is meant to be compacted at close to the right moisture. Dry base rock does not lock up well; a light spray of water before rolling helps.
Hauling 11 yards
At about 16.5 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices road base by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
When to choose road base
Best suited to:
- Base under asphalt and concrete
- Gravel roads and drives
- Equipment and shed pads
Think twice for:
- Drainage layers
- Decorative surfaces
- Surfaces that will stay uncompacted
Quick reference numbers
- Per inch over 100 sq ft: about 0.46 tons of road base (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.6 tons.
- Another size for comparison: a 10x20 area at 2 inches takes about 1.9 tons.
- Weight used here: about 1.5 tons per cubic yard.
Mistakes that throw off the order
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Questions people ask
How many tons is 11 yards of road base?
About 16.5 tons, with a typical range of 15.4 to 18.1.
How many pounds is 11 cubic yards of road base?
About 33,000 pounds.
How much area does 11 yards of road base cover at 6 inches?
About 594 square feet.
Why does road base weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 9 Cubic Yards of Road Base in Tons
- 10 Cubic Yards of Road Base in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.