14 Cubic Yards of Gravel in Tons
14 cubic yards of gravel in tons works out to about 19.6 tons using a planning weight of 1.4 tons per yard. Real loads land between roughly 18.2 and 21.0 tons depending on stone size, fines and moisture. That is about 39,200 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 14 × 1.4 = 19.6 tons.
- Low end: 14 × 1.3 = 18.2 tons.
- High end: 14 × 1.5 = 21.0 tons.
If your supplier quotes a different weight per yard, multiply by theirs.
What 14 yards covers
| Depth | Square feet |
|---|---|
| 2 in | 2,268 |
| 3 in | 1,512 |
| 4 in | 1,134 |
| 6 in | 756 |
About gravel
Because ’gravel’ covers so many products, the weight per yard moves with stone size and how much fine material is in the pile. Rounded stone with no fines rolls under tires; crushed stone with fines locks together.
Hauling 14 yards
At about 19.6 tons, this is more than one typical truckload. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices gravel by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Where gravel fits
Good uses:
- Rural driveways and lanes where low upfront cost matters
- Drainage areas and around downspouts
- Temporary access while a site is under construction
Less suited to:
- Steep slopes, where loose stone washes downhill
- Spots plowed often, since plows push gravel into the lawn
- Areas next to doors, because stone tracks inside
Quick reference numbers
- Per inch over 100 sq ft: about 0.43 tons of gravel (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.3 tons.
- Another size for comparison: a 8x16 area at 4 inches takes about 2.2 tons.
- Weight used here: about 1.4 tons per cubic yard.
Where estimates go wrong
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
Questions people ask
How many tons is 14 yards of gravel?
About 19.6 tons, with a typical range of 18.2 to 21.0.
How many pounds is 14 cubic yards of gravel?
About 39,200 pounds.
How much area does 14 yards of gravel cover at 4 inches?
About 1,134 square feet.
Why does gravel weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- How Much Does a Ton of Gravel Cover? Depth Chart
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 12 Cubic Yards of Gravel in Tons
- 13 Cubic Yards of Gravel in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.