15 Cubic Yards of Limestone Screenings in Tons
15 cubic yards of limestone screenings in tons works out to about 21.0 tons using a planning weight of 1.4 tons per yard. Real loads land between roughly 19.5 and 22.5 tons depending on stone size, fines and moisture. That is about 42,000 pounds.
Volume and tonnage calculator →The conversion
- Yards × tons per yard: 15 × 1.4 = 21.0 tons.
- Low end: 15 × 1.3 = 19.5 tons.
- High end: 15 × 1.5 = 22.5 tons.
The scale ticket on delivery day is the final word on weight.
What 15 yards covers
| Depth | Square feet |
|---|---|
| 1 in | 4,860 |
| 2 in | 2,430 |
| 3 in | 1,620 |
About limestone screenings
Screenings hold moisture and can crust over. Use them in thin layers over a compacted stone base instead of as a thick layer on their own.
Hauling 15 yards
Plan the delivery around 21.0 tons: two or more trucks in most areas. A pickup is a poor fit for anything past a fraction of a yard; see how much gravel a half-ton pickup can carry.
Before you order
- Confirm whether the yard prices limestone screenings by the ton or by the yard.
- Add about 10 percent for compaction and uneven ground.
- Clear a firm spot for the truck to dump.
The volume and tonnage calculator converts any area and depth into yards and tons.
Where limestone screenings fits
Best suited to:
- Paver and flagstone setting beds
- Firm walking paths
- Top-dressing a compacted stone base
Poor fit for:
- Deep layers on their own
- Low spots that collect water
- Under heavy vehicle traffic without a base
Quick reference numbers
- Per inch over 100 sq ft: about 0.43 tons of limestone screenings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.3 tons.
- Another size for comparison: a 20x25 area at 3 inches takes about 6.5 tons.
- Weight used here: about 1.4 tons per cubic yard.
Where estimates go wrong
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Skipping drainage. Water sitting under any surface softens the base and leads to ruts and potholes.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Questions people ask
How many tons is 15 yards of limestone screenings?
About 21.0 tons, with a typical range of 19.5 to 22.5.
How many pounds is 15 cubic yards of limestone screenings?
About 42,000 pounds.
How much area does 15 yards of limestone screenings cover at 2 inches?
About 2,430 square feet.
Why does limestone screenings weight vary?
Stone size, the share of fines and moisture all change how much a yard weighs.
Is it better to buy by the ton or the yard?
Either works; just convert with the supplier’s own weight per yard so the two quotes compare fairly.
Related guides
- #10 Stone (Stone Dust): Size, Uses and How Many Tons
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Yard of Crushed Stone Weigh?
- 13 Cubic Yards of Limestone Screenings in Tons
- 14 Cubic Yards of Limestone Screenings in Tons
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.