How Much #57 Stone for a 10x10 Chicken Run?
How much #57 stone for a 10x10 chicken run: about 1.2 tons at 3 inches deep. The area is 100 square feet, which is 0.93 cubic yards at that depth.
Volume and tonnage calculator →The math
- Area: 100.0 sq ft.
- Depth in feet: 3 ÷ 12 = 0.250 ft.
- Cubic yards: 100.0 × 0.250 ÷ 27 = 0.93 yd³.
- Tons: × about 1.35 tons per yard = 1.2 tons.
The crushed stone calculator does this for any size.
Related: How Much #57 Stone for a 10x12 Chicken Run?
#57 stone needed by depth
| Depth | Cubic yards | Tons of #57 stone | Tons +10% |
|---|---|---|---|
| 2 in | 0.62 | 0.8 | 0.9 |
| 3 in | 0.93 | 1.2 | 1.4 |
| 4 in | 1.23 | 1.7 | 1.8 |
| 6 in | 1.85 | 2.5 | 2.8 |
Chicken Run tips
Chickens scratch, so a run floor of washed stone 3 to 4 inches deep holds up better than bare soil. Grade the run so water runs out of it, and hose or rake the stone clean as needed.
Related: How Much #57 Stone for a 10x20 Chicken Run?
Before the stone goes in
Remove sod and roots, level the area and slope it slightly for drainage. Install edging so the stone stays inside the footprint.
Ordering and delivery
Most quarries and landscape yards deliver by the ton; ask whether there is a minimum and a delivery fee, and where the driver can dump without damaging your lawn. #57 is a washed stone of roughly 1/2 to 1 inch with few fines; it drains fast but stays a little loose on its own. The scale ticket is the real weight; tons per yard here is a planning figure.
Tools for the job
A flat shovel, a steel rake, a wheelbarrow and a rented plate compactor cover most residential pads. A landscape rake or the back of a rake levels the top layer, and a long straightedge or a level string shows high and low spots before the final pass.
Common mistakes
The most frequent problem is ordering for the finished depth without allowing for compaction, which can shrink a loose layer by 10 to 20 percent. Another is skipping fabric on soft soil and watching the stone vanish into the mud over the first wet season. Spreading everything in one thick layer instead of compacted lifts also leaves a soft, rutted surface.
Questions people ask
How many tons of #57 stone for a 10x10 chicken run?
About 1.2 tons at 3 inches deep.
How many yards of #57 stone for a 10x10 chicken run?
About 0.93 cubic yards.
How many tons of #57 stone are in a cubic yard?
Roughly 1.35 tons for planning, but suppliers vary with stone size and moisture.
Do I need to compact it?
Yes for anything that carries weight. Compact in lifts of a few inches with a plate compactor.
Related guides
- Gravel for a Chicken Run: Best Stone, Depth and Tons
- How Much Does a Ton of Gravel Cover? Depth Chart
- Tons to Cubic Yards for Gravel: Conversion Chart
- Crushed Stone vs Gravel: Differences and Best Uses
- Geotextile Fabric for Driveways: Woven vs Nonwoven and How Much You Need
- Compacting a Driveway Gravel Base in Lifts
- How Much Pea Gravel for a 10x10 Chicken Run?
- How Much Gravel for a 10x10 Chicken Run?
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.