How Much Crusher Run for 500 Square Feet?
How much crusher run for 500 square feet depends on depth. At 6 inches you need about 9.26 cubic yards, roughly 14.4 tons at 1.55 tons per yard. At 3 inches the order drops to 7.2 tons.
Volume and tonnage calculator →Crusher run for 500 sq ft by depth
| Depth | Cubic yards | Tons | Tons +10% |
|---|---|---|---|
| 3 in | 4.63 | 7.2 | 7.9 |
| 4 in | 6.17 | 9.6 | 10.5 |
| 6 in | 9.26 | 14.4 | 15.8 |
| 8 in | 12.35 | 19.1 | 21.0 |
Working it out
- 500 sq ft × (6 ÷ 12) ft = 250.0 cubic feet.
- ÷ 27 = 9.26 cubic yards.
- × 1.55 tons per yard = 14.4 tons.
About crusher run
The fines in crusher run fill the gaps between stones, so it weighs more per yard than clean stone once compacted. Plan on rolling or plate-compacting it in lifts. Expect the weight to fall in the range of 1.5 to 1.7 compacted tons per yard.
Ordering checklist
- Measure odd shapes in pieces. Split curves and L-shapes into rectangles and add them.
- Add a margin. About 10 percent covers compaction and low spots.
- Bulk or bags. Bulk delivery is the practical choice here.
- Prep first. Remove sod, compact the subgrade and set edging before the stone arrives.
Use the volume and tonnage calculator for any other size.
When to choose crusher run
Good uses:
- Base under asphalt, pavers or concrete
- Gravel drives that need a firm, packed surface
- Shed pads and equipment pads
Less suited to:
- Drainage layers, since the fines slow water
- Decorative beds
- Spots where you want water to soak straight through
Quick reference numbers
- Per inch over 100 sq ft: about 0.48 tons of crusher run (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.8 tons.
- Another size for comparison: a 20x25 area at 4 inches takes about 9.6 tons.
- Weight used here: about 1.55 tons per cubic yard.
Where estimates go wrong
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Questions people ask
How many tons of crusher run for 500 square feet?
About 14.4 tons at 6 inches deep.
How many cubic yards of crusher run for 500 square feet?
About 9.26 yards at 6 inches.
How much crusher run for 500 square feet at 3 inches?
About 7.2 tons, or 4.63 cubic yards.
How much does a yard of crusher run weigh?
About 1.5 to 1.7 compacted tons.
Should I add extra?
Yes, about 10 percent is a common allowance.
Related guides
- Crushed Stone vs Gravel: Differences and Best Uses
- Tons to Cubic Yards for Gravel: Conversion Chart
- How Much Does a Ton of Gravel Cover? Depth Chart
- How Much Crusher Run for 300 Square Feet?
- How Much Crusher Run for 400 Square Feet?
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.