Tons of Asphalt Millings per Mile of 10 ft Road
Tons of asphalt millings per mile of 10 foot road: about 847 tons at 4 inches deep. The strip is 10 ft × 5,280 ft = 52,800 square feet. Long runs magnify small depth changes, so pin the depth down before ordering.
Volume and tonnage calculator →Tons by depth
| Depth | Tons | Truckloads (~14 t) |
|---|---|---|
| 3 in | 636 | 46 |
| 4 in | 847 | 61 |
| 6 in | 1,271 | 91 |
| 8 in | 1,695 | 122 |
The math
- Area: 10 × 5,280 = 52,800 sq ft.
- Volume at 4 in: 52,800 × 0.333 = 17,600 cu ft (652 cubic yards).
- × 1.3 tons per yard = 847 tons.
Building a road this width
At 10 feet wide, this is a single-lane private road or farm lane. Asphalt millings are ground-up old pavement. When compacted and warmed by sun they bind into a fairly firm surface, which is why they are popular for rural drives and lots. Crown the surface so water sheds to ditches on both sides.
Practical notes
- Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
- Waste. Allow 5 to 10 percent.
- Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.
Check other sizes with the volume and tonnage calculator.
Good and poor uses for asphalt millings
Best suited to:
- Rural driveways and farm lanes
- Parking areas where a dust-free surface is wanted
- Low-cost base under a future paved surface
Less suited to:
- Areas near wells or streams where local rules limit them
- Decorative or barefoot areas
- Jobs needing a uniform, clean look
Quick reference numbers
- Per inch over 100 sq ft: about 0.40 tons of asphalt millings (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.0 tons.
- Another size for comparison: a 12x24 area at 4 inches takes about 4.6 tons.
- Weight used here: about 1.3 tons per cubic yard.
Common estimating mistakes
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Questions people ask
How many tons of asphalt millings per mile of 10 ft road?
About 847 tons at 4 inches.
How many truckloads is that?
About 61 loads at roughly 14 tons each.
How many square feet is mile of 10 ft road?
52,800 square feet.
Should I add extra for waste?
Yes, 5 to 10 percent is common.
Does this include the shoulders?
No. Measure shoulders and pullouts separately and add them.
Related guides
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- Asphalt Hauling Cost Per Ton: What Drives the Delivered Price
- Crushed Stone vs Gravel: Differences and Best Uses
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.