Tons of Asphalt per Mile of 10 ft Road
Tons of asphalt per mile of 10 foot road: about 957 tons at 3 inches compacted. The strip is 10 ft × 5,280 ft = 52,800 square feet. Shoulders, pullouts and turnarounds add to the total; measure them separately.
Asphalt tonnage calculator →Tons by depth
| Depth | Tons | Truckloads (~14 t) |
|---|---|---|
| 2 in | 638 | 46 |
| 3 in | 957 | 69 |
| 4 in | 1,276 | 92 |
The math
- Area: 10 × 5,280 = 52,800 sq ft.
- Volume at 3 in: 52,800 × 0.250 = 13,200 cu ft.
- × 145 lb ÷ 2,000 = 957 tons.
Road section basics
A 10-foot width fits one lane of traffic. Paved roads sit on a compacted aggregate base, ordered separately from the asphalt. Crown the surface so water sheds to ditches on both sides.
Practical notes
- Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
- Waste. Allow 5 to 10 percent.
- Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.
Check other sizes with the asphalt tonnage calculator.
Where asphalt fits
Good uses:
- Driveways, parking pads and private lanes that need a smooth, sealed surface
- Overlays on old pavement that is cracked but still structurally sound
- Areas where snow will be plowed, since a paved surface does not throw stone
Think twice for:
- Ground that stays soft or wet, unless the base and drainage are fixed first
- Very small patches, where bagged cold patch is often simpler
- Jobs in cold weather, since hot mix needs warm temperatures to compact properly
Quick reference numbers
- Per inch over 100 sq ft: about 0.62 tons of asphalt (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 6.2 tons.
- Another size for comparison: a 10x20 area at 4 inches takes about 4.9 tons.
- Weight used here: about 2.0 tons per cubic yard (roughly 145 lb per compacted cubic foot).
Where estimates go wrong
- Using inches as if they were feet. Depth has to be divided by 12 before you multiply; skipping that step inflates the order twelvefold.
- Measuring only the main rectangle. Aprons, turnouts and curved edges add real square footage.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Questions people ask
How many tons of asphalt per mile of 10 ft road?
About 957 tons at 3 inches.
How many truckloads is that?
About 69 loads at roughly 14 tons each.
How many square feet is mile of 10 ft road?
52,800 square feet.
Should I add extra for waste?
Yes, 5 to 10 percent is common.
Does this include the shoulders?
No. Measure shoulders and pullouts separately and add them.
Related guides
- How Many Tons in a Truckload of Asphalt?
- Asphalt Hauling Cost Per Ton: What Drives the Delivered Price
- Crushed Stone vs Gravel: Differences and Best Uses
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.