Tons of Crusher Run per Mile of 10 ft Road
Tons of crusher run per mile of 10 foot road: about 1,516 tons at 6 inches deep. The strip is 10 ft × 5,280 ft = 52,800 square feet. Long runs magnify small depth changes, so pin the depth down before ordering.
Volume and tonnage calculator →Tons by depth
| Depth | Tons | Truckloads (~14 t) |
|---|---|---|
| 3 in | 758 | 55 |
| 4 in | 1,010 | 73 |
| 6 in | 1,516 | 109 |
| 8 in | 2,021 | 145 |
The math
- Area: 10 × 5,280 = 52,800 sq ft.
- Volume at 6 in: 52,800 × 0.500 = 26,400 cu ft (978 cubic yards).
- × 1.55 tons per yard = 1,516 tons.
Building a road this width
A 10-foot width fits one lane of traffic. Crusher run (also sold as crush and run, dense-grade aggregate or QP in some regions) mixes stone with stone dust. It compacts into a firm, nearly solid layer, which makes it the usual base under pavers, asphalt and gravel drives. Crown the surface so water sheds to ditches on both sides.
Practical notes
- Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
- Waste. Allow 5 to 10 percent.
- Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.
Check other sizes with the volume and tonnage calculator.
Good and poor uses for crusher run
Good uses:
- Base under asphalt, pavers or concrete
- Gravel drives that need a firm, packed surface
- Shed pads and equipment pads
Think twice for:
- Drainage layers, since the fines slow water
- Decorative beds
- Spots where you want water to soak straight through
Quick reference numbers
- Per inch over 100 sq ft: about 0.48 tons of crusher run (0.31 cubic yards).
- Per inch over 1,000 sq ft: about 4.8 tons.
- Another size for comparison: a 14x28 area at 2 inches takes about 3.8 tons.
- Weight used here: about 1.55 tons per cubic yard.
Common estimating mistakes
- Assuming every supplier uses the same weight. Two yards selling the same product name can quote different tons per yard.
- Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.
- Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
- Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Questions people ask
How many tons of crusher run per mile of 10 ft road?
About 1,516 tons at 6 inches.
How many truckloads is that?
About 109 loads at roughly 14 tons each.
How many square feet is mile of 10 ft road?
52,800 square feet.
Should I add extra for waste?
Yes, 5 to 10 percent is common.
Does this include the shoulders?
No. Measure shoulders and pullouts separately and add them.
Related guides
- How Many Tons of Gravel in a Dump Truck? Loads and Coverage
- Asphalt Hauling Cost Per Ton: What Drives the Delivered Price
- Crushed Stone vs Gravel: Differences and Best Uses
As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.