Tons of Asphalt Millings per Mile of 32 ft Road

Tons of asphalt millings per mile of 32 foot road: about 2,712 tons at 4 inches deep. The strip is 32 ft × 5,280 ft = 168,960 square feet. Shoulders, pullouts and turnarounds add to the total; measure them separately.

Volume and tonnage calculator →

Tons by depth

Depth	Tons	Truckloads (~14 t)
3 in	2,034	146
4 in	2,712	194
6 in	4,068	291
8 in	5,423	388

The math

Area: 32 × 5,280 = 168,960 sq ft.
Volume at 4 in: 168,960 × 0.333 = 56,320 cu ft (2,086 cubic yards).
× 1.3 tons per yard = 2,712 tons.

Road section basics

At 32 feet wide, this is a two-lane road width. Asphalt millings are ground-up old pavement. When compacted and warmed by sun they bind into a fairly firm surface, which is why they are popular for rural drives and lots. Crown the surface so water sheds to ditches on both sides.

Practical notes

Phasing. Large tonnages are delivered over days; schedule spreading and compaction to keep up with trucks.
Waste. Allow 5 to 10 percent.
Hauling. Distance from the quarry or plant often costs as much as the material on long jobs; see asphalt hauling cost per ton.

Check other sizes with the volume and tonnage calculator.

Good and poor uses for asphalt millings

Best suited to:

Rural driveways and farm lanes
Parking areas where a dust-free surface is wanted
Low-cost base under a future paved surface

Poor fit for:

Areas near wells or streams where local rules limit them
Decorative or barefoot areas
Jobs needing a uniform, clean look

Quick reference numbers

Per inch over 100 sq ft: about 0.40 tons of asphalt millings (0.31 cubic yards).
Per inch over 1,000 sq ft: about 4.0 tons.
Another size for comparison: a 15x30 area at 3 inches takes about 5.4 tons.
Weight used here: about 1.3 tons per cubic yard.

Where estimates go wrong

Ignoring the base. A thin surface layer over soft soil fails early no matter how much material is on top.
Ordering exactly the math. Uneven ground and spillage nearly always need a little more than the flat calculation.
Forgetting that compaction shrinks loose material. A loose 4-inch spread of a dense-graded stone may finish closer to 3 inches after rolling.
Mixing up cubic yards and tons. Yards are volume, tons are weight; convert with the product’s weight per yard.

Questions people ask

How many tons of asphalt millings per mile of 32 ft road?

About 2,712 tons at 4 inches.

How many truckloads is that?

About 194 loads at roughly 14 tons each.

How many square feet is mile of 32 ft road?

168,960 square feet.

Should I add extra for waste?

Yes, 5 to 10 percent is common.

Does this include the shoulders?

No. Measure shoulders and pullouts separately and add them.

As an Amazon Associate, AsphaltTons.com earns from qualifying purchases. Product links below are sponsored.